Bed Wood - "Premium" Grade
Our Premium Quality Oak Bed Wood is a step above our Standard Grade wood. Premium sets are hand selected in order to provide boards with similar grain, pattern, and color. Each set is graded in-house and only those boards that are deemed "Show Quality" are used in our Premium Wood sets.
Your bed is the largest surface of your Classic Truck and its structure and appearance is crucial to it's look and ride. At Classic Parts we know how important using the right quality of wood is when restoring your Classic Truck. Therefore, we use only the highest quality, cabinet grade, kiln-dried, red oak. Our wood is cut to size, with edges grooved, ready to install and finish. All boards are 3/4" thick and are cut to exact widths to match the original GM bed patterns.
Although wood is a natural product and will vary in grain, color, pattern and character, we hand select and sort our wood to provide you with the best quality product at the lowest price. So ... whether you are restoring your own classic truck or just want to repair what you have...Classic Parts understands how important the quality and integrity of your bed wood is to your project. Buy from us with confidence
-
Premium Show Quality cabinet grade Red Oak
-
Hand selected for matching grain, color, and pattern
-
Kiln Dried for stability
-
Trimmed to Length
-
Cut to width to match original bed patterns
-
Manufactued in USA
*Please Note: This item is "Oversized" and requires an Oversized Shipping Charge as noted above. Wood is a natural product that is susceptible to humidity, rain, sun, and weather conditions. Classic Parts recommends that you stain, paint or seal your wood to protect it from checking, spitting, and cracking.
(We will try to pack your items in a way that will help to consolidate shipping charges and pass on any savings to you at the time of invoicing.)
Wood Finish Tips
(This is a suggestion only!)
We suggest you consult with a local finish or woodworking/cabinetry shop for the best finish to use.
Location and climate vary so there may be more suitable application for your specific area.
Mounting holes need to be located and drilled before you apply wood finish so that the insides of all holes will be sealed.
You will need to completely finish the wood before installing.
Procedure:
- 1. Sand with a fine grit sand paper.
- 2. Clean boards with lacquer thinner using soft clean rags. Be sure there are no grease marks or finger prints anywhere on the wood.
- 3. Apply wood sealer
*follow instructions according to the sealer you use.
- 4. Allow the sealer to dry the recommended time.
- 5. Apply 2-5 coats of oil base Exterior Varnish
**Note: Be sure to apply the finish to all areas of the boards, ends, holes, edges, 6. tops and bottoms.
- 6. Allow to dry between each coat.
- 7. Sand lightly between coats of varnish.
|
